hardware cloth of the iron wire
DSH - 1 type iron wire stapler, in large, medium and small enterprises printing and binding is widely used in all kinds of books and magazines played an important role. First, a stapler wire feeding, cutting through, molding, order books, equal five parts, usually on the side hardware cloth, feeding and packing due to complex structure, precision, stapler binding books in daily so, when malfunction occurs, affect the quality and schedule of binding books. According to his years in production, an encounter failure analysis, for reference.
1. Don't normally send wire or not send wire. The main reason is: transportation or send skateboard (orbit) etc packing conveying the groove, wear wire cannot rhythmically correct transmission, leakage, don't send phenomenon, Wire unqualified, burr, not smooth or not will affect the normal flat wire.
2 don't cut wire or cut. Mainly cutters and the guidewire hole section. Such as: cutting knife down than scheduled and eye contact when godet too small, Cutting knife with large distances, the guidewire when cut materials (collapse), cannot blade formed shearing action, Cutting edge collapse is serious damage.
3 don't molding (for) : mainly molding sawing with hooks and moulding board. Such as: shaping hook feeding, Molding hook and clip board has sent out wear, wire, Clip reed, wire clip feeding failure could not send a, etc.
Sawing (4) card wire stuck). Mainly molding hook inappropriate. Such as: shaping hook, wire in wear, wire stuck groove, Wire without straightening, force transmission in place and gets stuck, Wire line diameter (usually) or improper too heavy sawing book.
5 nail saws length of irregular (order claw. Main transmission is not normal. Such as: adjust feeding swing, feeding or skateboarding wear, wire feeding can regularly.
6 feet) claws (book, a book for a short or long are short, The main reason is improper adjustment. According to the thickness of the book, when adjusted to adjust the length of appropriate book claw after.
7. ChuJian feet bent nails saws. This often occurs in the nail thicker stiff book, is a difficult fault. Its form is on the back of the book in order in the corner of the fault fracture and not pointed to seal face, saws, causing broken or sliding cover losses. Roughly three reasons: wire sizes, pressure, or tight claws (hold claw) push board, will ChuJian epigastric top wire.
8. Order claw (foot) nail inaccurate or a compaction a pressure. Reason: tight claws (hold claw) push board is too low, when to reserve, cannot be nailed, torre claw on a tight claws (hold claw) height inconsistency or not up to a parallel.
9 order claw into crooked. Main reasons, wire quality is bad, have not smooth flat; burr, The soft wire, and ordered book, After each Angle according to the vertical nail doesn't, Molding skateboarding inappropriate groove, such as too wide, through the narrow or improper pressure plate etc.
The book book should be chosen according to the thickness of the book, and ordered board type, wire length regulating relative requirements book claw.
11. Adjust "tight", claws beyond 2-3mm plane. According to the operation, the books will be bound to meet the quality requirements.